آنتن سلولی اکسترنال مغناطیسی پرقدرت ⁦Proxicast⁩ مدل ۸ ⁦dBi⁩، ⁦4G/5G⁩، سازگار با ⁦AT⁩&⁦T Nighthawk M6/MR6110⁩ و ⁦MR6500⁩، ⁦M5/MR5200⁩، ⁦M1/MR1100⁩، ⁦Verizon 8800L⁩ و هات‌اسپات‌های دارای کانکتور ⁦TS9⁩ (⁦ANT-006-TS9-2PK⁩)

معرفی

Product Description Proxicast 8 dBi High Gain External Magnetic Antenna Compatible with AT&T Nighthawk, USB800, Velocity, Verizon Jetpack 8800L, 7730L & Devices with TS9 Jacks Includes Proxicast's 4G/LTE high-gain omni-directional antenna + extra large 3 in. magnetic antenna base with 79 in. (6.6 ft) of low-loss coax cable and TS9 plug. The detachable polycarbonate antenna swivels 90 degrees and rotates 360 degrees; magnetic base and long coax cable allow optimal positioning for maximum signal reception. Compatible with many 4G/LTE modems having TS9 external antenna connectors including (partial list): AT&T Nighthawk / Netgear Mr5100 / M5, MR1100 / M1 USB800 Unite Express 2 (AC797S) Unite Express (AC779S) Unite Explore (AC815S) Unite Pro (781S) Velocity 2 / ZTE MF985 Velocity / ZTE MF861, MF923 Beam / Netgear 340U Momentum / Sierra 313U Unite / Netgear AC770s Elevate / Sierra 754S Verizon JetPack AC791L, MiFi 6620L, 7730L, 8800L Novatel 551L, U620L, USB730L Novatel USB760, Pantech MHS291L, MHS800L Sprint MiFi 8000, Fuse, Zing (771S), Netgear 341U T-Mobile Huawei E587, Sonic, UMG366, Jet 2.0, ZTE MF61 Netgear LB2120, LB1121, LB1120 Electrical Properties Impedance: 50 ohms Peak Gain: 8 dBi Radiation: Omni Ground Plane: Integrated Mechanical Properties Connector: TS9 (plug) Material: Polycarbonate / Steel / Brass / Rubber Op. Temp: -30 to +75C Coax Cable: 79 in / 200 cm LMR100 Low Loss Overall Height: 13.25 in. / 33.7 cm Diameter Base: 3 in. / 70 mm Diameter Antenna: 0.51 in. / 13 mm Small hole on the top of the antenna is by design and is not a defect. LTE devices should use 2 identical antennas for best results. High gain antennas are appropriate when signal strength is below 60%. Not intended for permanent outdoor use. TS9 Connectors Are Delicate TS9 connectors are compression fit - they are not intended for repeated insertions and removals. When inserting/removing the male connector, hold by the silver block and push/pull straight in/out. Pulling at an angle will loosen the male connector. Don't Push Too Hard The TS9 connector is *NOT* designed to fit all the way into the modem's external antenna port. Pressing the connector into the modem too firmly can damage the device. Fix a Loose Connection If the TS9 connector becomes loose, gently squeeze the opposing blades on the tip with tweezers or needle-nose pliers. Read more Read more