کیت حصیر گرمایش کف برقی ⁦⁦HEATWAVE⁩⁩، مساحت ۱۰ فوت مربع، ولتاژ ⁦⁦120V⁩⁩، جریان ⁦⁦1A⁩⁩، توان ⁦⁦120W⁩⁩، با ترموستات ⁦⁦GFCI⁩⁩ قابل برنامه‌ریزی ۷ روزه ۴ مرحله‌ای

معرفی

Product Description Heatizon's Heatwave System is the best and most versatile floor warming system available. The systems are easy to install and allow for custom installation configurations. Unlike our competitors, every system comes with a programmable thermostat standard. Heatwave is available as pre-configured mat or free-roll cable and in 120 or 240 voltages. We also offer various upgrades and expansion options (see flyer in box). Programmable Thermostat Heatwave standard thermostat (M429) specifications: Up to 4 event programming Simple user interface Pre-programmed for quick set up Multi voltage: 120/208/240 V Output Relay 15A Can be set to automatic, manual, or comfort mode Includes 2 sensors: a built-in air sensor and floor sensor thermistor with 10 feet of NTC (12K) sensor cable Temperature control range: 41oF to 104oF Class A GFCI (5 mA trip level) Read more An Efficient System The Heatwave system comes with a 10-foot long floor sensor standard for optimal use of your Heatwave System. Extra compatible sensors are available on our store page. Read more Fully Embedded System Heatwave can be embedded in various types of cement-like material, allowing for several floor covering options. Embedding Heatwave allows for optimal heat dispersion and gives the end-user a nice, consistently warmed floor. Read more Be sure to get the right size! Heatwave comes in various sizes to accommodate differing size spaces. It is important to accurately measure the space you intend heat. Avoid placing the heating cable under vanities, within 6-inches of the toilet gasket and under other permanent fixtures in the space. It is acceptable to place Heatwave in a shower, provided that is still fully embedded in a thinset/or Mortar. Be aware the heating cable cannot be cut or shortened in anyway. Read more Get the Right Size Be sure to order a Heatwave system for the area to BE HEATED, not the total area. The Heatwave heating element CANNOT be cut or shortened to a fit a space. Smaller size systems are available to fit smaller areas. Avoid performing any cutting/drilling tasks on a finished/partially finished floor that could cause damage to heating element. Don't Power on Until... Do not power on the Heatwave System until it has been completely embedded in a cement-based compound (thinset/mortar/self-leveling) and that compound is completely dried. Do not power on a Heatwave System to "test" or to dry out an embedding compound. Completely Embed The Heatwave cable MUST be completely embedded (unable to be seen) in a cement-based compound (thinset/mortar/self-leveling). Both connection/junction points must also be fully embedded, the connection point at the end of the heating element and the connection point between the red heating cable and the black unheated (cold lead) cable. Ensure that air pockets in mortar/thinset/self-leveling compound with exposed heating element, get fully filled-in. Perform All Tests Perform all required tests outlined in the installation manual at several stages throughout installation to ensure that heating element has not been damaged. Failure to perform all the required tests at several stages can cause system damage to be missed which can lead to system errors, ground faults, non-functional systems, and unrepairable damage. Read more